Clean the chaff outlet and auger
How to clean the chaff outlet and auger on the P3000 at the end of each production week.
Contents
When to clean the chaff outlet and auger
Before you start
Tools required
Instructions
When to clean the chaff outlet and auger
Clean the chaff outlet and auger at the end of each production week.
Before you start
DISCLAIMER
The information in this document is believed to be accurate and reliable. However, the manufacturer does not give any representations or warranties, expressed or implied, as to the accuracy or completeness of such information and shall have no liability for the consequences of the use of such information. The manufacturer is not liable or responsible for any problems arising from the attempted repair. The manufacturer reserves the right to make changes to information published in this document, including without limitation specifications and product descriptions, at any time and without notice. The manufacturer's products are not designed, authorized, or warranted to be suitable for use in applications where failure or malfunction can reasonably be expected to result in personal injury, death, or severe property or environmental damage. The manufacturer accepts no liability for inclusion and/or use of its products in such equipment or applications and therefore such inclusion and/or use is for the customer’s own risk.
SAFETY INSTRUCTIONS
-
Make sure the roaster is turned off before starting any maintenance work.
-
The power cord must be unplugged or the roaster fully isolated from the electrical supply before removing any panels.
-
Read the instructions in full before starting work, and follow the steps as instructed below.
- Make sure the roaster has completely cooled down before doing any maintenance work.
Tools required
- Vacuum cleaner
- Long nylon brush
- Soft brush or microfiber cloth
- Sponge
- Espresso machine cleaner
Instructions
Locate the chaff outlet and auger
The chaff outlet and auger are at the back of the roaster. The chaff bin is connected to the elbow on the outlet.

Access the chaff outlet and auger
Remove the chaff bin first.
Remove the tri-clamp that holds the elbow in place, then remove the elbow.


Remove the disk and the auger.


Clean the chaff outlet and auger
Use the long nylon brush to loosen debris and dust inside the outlet, then remove it with a vacuum cleaner. Clean the auger with a soft brush or microfiber cloth.


If the auger is covered in coffee oils, soak it in warm water and espresso machine cleaner. Use a sponge to clean it off. Make sure it is completely dry before reinstalling.
Finish up
Reassemble the parts in reverse order.