Skip to content
CONTACT SUPPORT
  • There are no suggestions because the search field is empty.

Clean the exhaust inspection hatch

How to open the inspection hatch and clean the exhaust exit on the P3000. Do this every week, as dust and coffee oils build up.

Contents

Before you start
Tools required
Instructions

Before you start

undefined DISCLAIMER

The information in this document is believed to be accurate and reliable. However, the manufacturer does not give any representations or warranties, expressed or implied, as to the accuracy or completeness of such information and shall have no liability for the consequences of the use of such information. The manufacturer is not liable or responsible for any problems arising from the attempted repair. The manufacturer reserves the right to make changes to information published in this document, including without limitation specifications and product descriptions, at any time and without notice. The manufacturer's products are not designed, authorized, or warranted to be suitable for use in applications where failure or malfunction can reasonably be expected to result in personal injury, death, or severe property or environmental damage. The manufacturer accepts no liability for inclusion and/or use of its products in such equipment or applications and therefore such inclusion and/or use is for the customer’s own risk.

undefined SAFETY INSTRUCTIONS

  • Make sure the roaster is turned off and cooled down before starting any maintenance work.

  • The power cord must be unplugged or the roaster fully isolated from the electrical supply before removing any panels.

  • Read the instructions in full before starting work, and follow the steps as instructed below

Tools required

  • Flat-head screwdriver, coin or similar to open the front door
  • Brush
  • Vacuum cleaner

Instructions

Open the front door

See instructions here.

Locate the inspection hatch

The inspection hatch is on the top plate of the drum.

Inspection hatch location

Open the inspection hatch

Loosen the wing nut on the leverage arm and move the arm out of the way. 

inspection hatch wing nutinspection hatch leverage arm

Move the inspection hatch plate out of the way.

inspection hatch removal

Use a brush and a vacuum cleaner to remove dust and other debris from inside the inspection hatch.

inspection hatch cleaning

Finish up

Put the inspection hatch plate and leverage arm back in place and fasten the wing nut finger tight. 

Close the front door.